Your dash cam uses LED indicators to inform you about its current operational status. Below is a structured overview of common LED alerts grouped by category:
General System
-
Turn On
Indicates that the camera is powering on or has been successfully turned on.
SD Card Related Indicators
-
Format SD Card
Indicates that your SD card needs formatting to ensure reliable recording and prevent errors.
-
No SD Card
The camera does not detect an SD card. Please insert a compatible SD card.
- Insert SD Card
Prompt shown when no SD card is detected. Please insert a supported SD card to continue.
-
SD Card Error
There is a problem with the SD card (e.g., corruption or write failure). Formatting or replacing the card may be necessary.
- Not Recording
Indicates that the camera is powered on but not currently recording. Check SD card status and settings
-
Recording a Protected File
The camera is saving a file that is protected from being overwritten, such as footage from an incident.
Recording Status
-
Normal Loop Recording
The camera is continuously recording in loop mode.
-
Crash Detection
The camera has detected an impact and is securing the current recording.
-
Witness Mode
The camera is recording but footage is not permanently saved.
GPS Status
-
GPS Locked
The camera has successfully connected to GPS satellites for accurate location and speed data.
-
Searching for GPS
The camera is attempting to acquire GPS signal.
Connectivity & Interaction
-
Wi-Fi Active
The camera’s Wi-Fi is on and ready for pairing or data transfer.
-
PC Connection Mode
The camera is connected to a computer for data transfer or charging.
-
Voice Command
Voice command mode is active and listening for your instructions.
-
Pairing Failed
The pairing attempt was unsuccessful. Please ensure the device is ready and try again.
-
Enter Pairing Mode
The camera is ready to be paired with a mobile device. Ensure Wi-Fi is enabled and follow pairing instructions.
-
Connecting 385
The camera is in the process of connecting to the 385 device or module.
-
Reset 385
Indicates a reset process is being performed on the 385 module.
Emergency & Error Alerts
-
ESOS Error
There is an issue with the Emergency SOS service that requires attention.
- Installing Update
A firmware or software update is currently being installed. Do not power off the device during this process.